Cisco Unified 8961 Setup Manual

Jelajahi secara online atau unduh pdf Setup Manual untuk Telepon IP Cisco Unified 8961. Cisco Unified 8961 4 halaman. Cisco systems telephone
Juga untuk Cisco Unified 8961: Catatan Rilis (16 halaman), Ikhtisar (30 halaman), Panduan Administrasi (8 halaman), Panduan Pengguna (48 halaman), Panduan Pengguna (10 halaman), Fitur (35 halaman), Mulai Cepat (2 halaman), Panduan Pengguna (22 halaman), Pengaturan (4 halaman), Panduan Memulai Cepat (2 halaman), Panduan Referensi Cepat (3 halaman), Manual (12 halaman), Referensi Cepat (4 halaman), Sekilas (3 halaman), Panduan Cepat (10 halaman), Panduan Memulai Cepat (2 halaman), (Bahasa Portugis) Panduan Memulai Cepat (2 halaman)

Setting Up the Cisco Unified Video Camera

The Cisco Unified IP Phone 9951 and 9971 supports the add-on accessory Cisco Unified Video Camera.

The Cisco Unified Video Camera connects to your Cisco Unified IP Phone and allows you to make a

point-to-point video call with another Cisco Unified IP Phone with a Cisco Unified Video Camera

attached. If a phone does not have a Cisco Unified Video Camera attached, it can only receive one-way

video.

This chapter contains the following information:

•

Configuring the Cisco Unified Video Camera

To configure the Cisco Unified Video Camera, you must perform the following configuration steps in

Cisco Unified Communications Manager administration:

Note

The parameters described in the following procedure can be enabled on either the Phone Configuration

window (Device > Phone), the Enterprise Phone Configuration window (System > Enterprise Phone

Configuration), or the Common Phone Profile window (Device > Device Settings > Common Phone

Profile). Be sure to also check the corresponding Override Common Settings parameter in the

configuration window. The Phone Configuration window is referenced below for purposes of the

procedure description.

For more information about parameters that can be configured in any of these three configuration

windows, see the

Procedure

In the phone configuration window (Device > Phone) of the phone to which you are adding the Cisco

Step 1

Unified Video Camera, enable the Cisco Camera parameter. This field is located in the Product Specific

Configuration layout portion of the window.

Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.0 (SIP)

OL-20862-01

Configuring the Cisco Unified Video Camera, page 5-1

Attaching the Cisco Unified Video Camera, page 5-2

Adjusting the Camera Settings, page 5-2

Post-Installation Steps, page 5-4

Using the Cisco Unified Video Camera, page 5-4

"Configuring Product Specific Configuration Parameters" section on page

C H A P T E R

8-20.

5-1