Ricoh SP 330SFN Manual - Halaman 15

Jelajahi secara online atau unduh pdf Manual untuk Printer Ricoh SP 330SFN. Ricoh SP 330SFN 26 halaman.

Ricoh SP 330SFN Manual
7.
Enter the encryption key using the number keys, and then
press the [OK] key.
Password
Key :
(8-63 chars/64 hex)
WPA2-PSK
• As the passphrase, you can enter either 8 to 63 ASCII characters
(0x20-0x7e) or 64 hexadecimal digits (0-9, A-F, a-f).
• For details about checking the encryption key, see "Checking the
SSID and Encryption key".
8.
Press the [OK] key.
Are you sure to connect?
(OK/Back)
9.
Check the result.
Connection has succeeded:
Connect succeed!
Connection has failed:
Connect failed!
• Check the configuration for the router (access point), and then
try the connection again.
10. Press the [ ] or [ ] key to select [Quit Setup], and then
press the [OK] key.
11. Press the [ ] or [ ] key to select to display [Network
Wizard] menu or not when you turn on the machine, then
press the [OK] key.
12. Configuring the Wireless (Wi-Fi) settings is complete.
13. To use the printer driver, install the printer driver according
to the procedure on page 17 "Easy Setup Using the
CD-ROM" and select "The machine's IP address has been
already configured." on step 6.
DSG353
DSG354
DSG355
DSG356
Easy Setup Using the WPS Button
™
SP 330SFN/3710SF
● Make sure the Ethernet cable is not connected to the
machine.
● In Steps 8 to 10, configure each setting within two
minutes.
The following item is necessary to set up a Wireless
(Wi-Fi) connection.
● Router (access point)
1.
Check that the router (access point) is working correctly.
2.
Make sure the wireless LAN option is attached to the
machine and the wireless (Wi-Fi) connection is enabled.
For details, see page 10 "Attaching the wireless LAN option".
3.
Press the Wireless (Wi-Fi) icon.
4.
If you are requested to enter a password, enter the
password using the number keys, and then press [OK].
A password for accessing the [Network Settings] menu can be
specified in [Admin. Tools Lock] under [Administrator Tools]
menu.
5.
Press [Wireless (Wi-Fi) Sett.].
6.
Press [WPS].
7.
Press [PBC].
8.
Press [Connect].
"Please wait for 2 minutes" appears, and the machine starts to
connect in PBC method.
9.
Press the WPS button on the router (access point) within
two minutes.
WPS
• For details about how to use the WPS button, refer to the manuals for
the router (access point).
10. Check the result.
Connection has succeeded:
"Connected to access point." is displayed.
Press [OK] to return to the screen displayed in Step 7, and then press
the [Home] key to return to the initial screen.
Connection has failed:
CHV607
13