Cisco 12016 Manual Petunjuk Penggantian - Halaman 12

Jelajahi secara online atau unduh pdf Manual Petunjuk Penggantian untuk Router Jaringan Cisco 12016. Cisco 12016 32 halaman. Blower module and air filter for cisco 12016, cisco 12416, and cisco 12816 router
Juga untuk Cisco 12016: Manual Petunjuk Pembongkaran Kemasan (28 halaman), Lembar data (9 halaman), Petunjuk Manual (16 halaman), Manual Petunjuk Penggantian (18 halaman)

Halaman Cetak

Removing and Installing the Chassis

Removing and Installing System Components

To remove and install system components from one chassis to another, follow these steps:

Remove the blower modules and then install them into the replacement chassis. Refer to the

Step 1

Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide for detailed

procedures.

Remove the power supplies and the power shelf and then install them into the replacement chassis. Refer

Step 2

to the Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide for

detailed procedures.

Step 3

Remove the cards from all three card cages and then install them into the replacement chassis.

•

Removing the Chassis from the Equipment Rack

This section provides the following procedures:

•

Detaching the Supplemental Bonding and Grounding Connection

If your router has supplemental bonding and grounding cables attached to any of the earth ground cable

receptacles on the chassis, you must detach these cable lugs from the chassis before you can remove the

chassis from the equipment rack. Two receptacles are located on the front flanges of the chassis, near the

lower corners of the switch fabric card cage (see

power interface panel on the back of the chassis (see

To detach a supplemental bonding and grounding cable lug from the chassis, use

a reference and follow these steps:

Step 1

Remove the two bolts, washers, and nuts that secure the bonding and grounding cable lug to the chassis.

Save the mounting hardware, because you will use it in a later procedure.

Remove the bonding and grounding cable and set it aside.

Step 2

Repeat

Cisco 12016, Cisco 12416, and Cisco 12816 Router Chassis Replacement Instructions

For the RP, refer to the RP installation and configuration note for detailed procedures.

For line cards, refer to the line card installation and configuration note for detailed procedures.

For CSCs, SFCs, and the alarm card, refer to the Cisco 12016, Cisco 12416, and Cisco 12816 Router

Installation and Configuration Guide for detailed procedures.

Detaching the Supplemental Bonding and Grounding Connection, page 12

Removing the Chassis from the Equipment Rack, page 13

Step 1

and

Step 2

for a second supplemental bonding and grounding connector (if present).

Figure

3) and two receptacles are located on top of the

Figure

4).

Figure 3

Figure 4

78-16082-01