Cisco 12816 Manual Petunjuk Penggantian - Halaman 21

Jelajahi secara online atau unduh pdf Manual Petunjuk Penggantian untuk Router Jaringan Cisco 12816. Cisco 12816 32 halaman. Blower module and air filter for cisco 12016, cisco 12416, and cisco 12816 router
Juga untuk Cisco 12816: Manual Petunjuk Pembongkaran Kemasan (28 halaman), Lembar data (9 halaman), Petunjuk Manual (16 halaman), Manual Petunjuk Penggantian (18 halaman)

Halaman Cetak

To attach a bonding and grounding cable lug to a bonding and grounding receptacle on the router, use

Figure 14

Locate the bonding and grounding receptacle on the router that you plan to use.

Step 1

Position the bonding and grounding cable lug over the bonding and grounding receptacle holes on the

Step 2

chassis.

Insert the two M6 bolts that you removed earlier through the holes in the cable lug and chassis, then

Step 3

install the locking washers and nuts.

Ensure that the bonding and grounding cable does not interfere with other router hardware, then tighten

Step 4

the nuts and bolts to secure the bonding and grounding cable lug to the chassis.

Repeat

Reattaching the Vertical Cable-Management Troughs

To reattach the vertical cable-management troughs, use

Step 1

Align the trough so that the access gate opens toward the front of the chassis.

Align the screw holes on the inside panel of the trough with the standoffs in the chassis rack-mounting

Step 2

flange near the upper horizontal cable-management tray.

Step 3

Use your fingers to insert screws into the two holes and screw them in to hold the trough in place.

Step 4

Insert a Phillips screwdriver through the access holes in the outer panel of the trough and loosely tighten

the two screws.

Step 5

Insert and start screws in the middle two standoffs and the bottom two standoffs.

Step 6

Check the alignment of the trough on all six holes, then use the Phillips screwdriver to tighten all six

screws.

Repeat

Completing the Installation

To complete the installation, follow these steps:

Reconnect power to the power shelf. Refer to the Cisco 12016, Cisco 12416, and Cisco 12816 Router

Step 1

Power System Procedures Guide for detailed procedures.

Reconnect the line card interface cables. Refer to the line card installation and configuration note for

Step 2

detailed instructions.

Reconnect the cables to the RP. Refer to the RP installation and configuration note for detailed

Step 3

procedures.

Reconnect any alarm card cabling. Refer to the Cisco 12016, Cisco 12416, and Cisco 12816 Router

Step 4

Clock and Scheduler, Switch Fabric, and Alarm Card Replacement Instructions for detailed procedures.

78-16082-01

Figure 15

as a reference and follow these steps:

Step 2

through

Step 4

for the second bonding and grounding connection, if required.

Step 1

through

Step 6

for the remaining trough.

Cisco 12016, Cisco 12416, and Cisco 12816 Router Chassis Replacement Instructions

Removing and Installing the Chassis

Figure 5

as a reference and follow these steps: