Cisco 1711 - Security Access Router Panduan Memulai Cepat - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Router Jaringan Cisco 1711 - Security Access Router. Cisco 1711 - Security Access Router 13 halaman. Security access routers
Juga untuk Cisco 1711 - Security Access Router: Lembar data (8 halaman), Panduan Pemasangan Perangkat Keras (21 halaman)
Halaman Cetak
7
Verifying Your Installation
You can verify that you have correctly installed your router by checking the LEDs as described in Table 1.
Table 1
LEDs That Verify Installation
LED
PWR
OK
LINK
FDX
100
ETH ACT
WIC1 ACT
WIC0 ACT
Switch port ACT
Switch port LNK
WIC0 OK and WIC1 OK
MOD OK
1. The analog modem WIC and the switch port WIC are not field replaceable.
8
Obtaining Documentation
Cisco documentation and additional literature are available on Cisco.com. Cisco also provides several ways to obtain technical
assistance and other technical resources. These sections explain how to obtain technical information from Cisco Systems.
Panel
What to Look For
Front
On when power is being supplied to the router.
Front
On when the router software is loaded and
functional.
Blinking when the router is running a power-on
self-test (POST). Continual blinking can indicate a
problem with the router, although the LED will
also blink if the router is in ROMMON mode.
Refer to the "Troubleshooting" chapter in the
Cisco 1711 and Cisco 1712 Security Access
Routers Hardware Installation Guide for more
information.
Back
On when the router is correctly connected to the
Ethernet network through the 10/100 Ethernet
port.
Back
On when the Ethernet port is operating in
full-duplex mode.
Back
On when the 10/100 Ethernet port is operating at
100 Mbps.
Front
Blinking when there is network traffic on the local
Ethernet LAN.
Front
Blinking when data traffic is being sent to or
received on the card in the WIC1 slot.
Front
Blinking when data traffic reaches the host CPU.
The traffic types include Cisco Discovery Protocol
(CDP), Spanning-Tree Protocol (STP),
inter-virtual local area network (VLAN) traffic,
and traffic that is routed between the switch ports
and WIC0 and/or the onboard Fast Ethernet port.
Back
On solid when data packets are being transmitted
or received in and out of the Ethernet port.
Off when there is no data activity.
Back
On solid when link is present.
Off when link is not detected.
1
Back
On when a WIC is correctly installed in the
corresponding WIC slot.
Back
On when the VPN hardware encryption module is
installed and recognized by the Cisco IOS
software.
7