Epson EMP-61 Panduan Referensi Cepat - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Referensi Cepat untuk Proyektor Epson EMP-61. Epson EMP-61 4 halaman. Esc/vp21 command user's guide for business projectors
Juga untuk Epson EMP-61: Panduan Pengguna (25 halaman), Panduan Pengguna (25 halaman), Panduan Pengguna (28 halaman), Panduan Pengguna (28 halaman), Panduan Referensi Cepat (4 halaman)
Halaman Cetak
Adjustments
Adjusting the image angle
While pulling the foot adjust lever, lift up the front of the projector
so that the front adjustable foot can extend.
To retract the front adjustable foot, gently push down on the
projector while pulling the foot adjust lever.
Foot adjust lever
When the projector is tilted, it will cause keystone distortion to
appear in the image, but this distortion can be corrected using the
automatic keystone correction function as long as the vertical
angle of tilt is within a range of approximately 15˚. If you would like
to make further minor adjustments to the result of automatic
keystone correction, use
The following adjustments can also be made.
Auto Setup (only when computer or RGB video signals are being projected)
Tip
User's Guide "Adjusting Computer Images and RGB Video Images"
projecting computer images, the input signals are detected automatically and adjusted
When
so that the optimum images are projected. If the results of automatic adjustment are not
satisfactory, individual settings can also be adjusted manually using the menus.
Other adjustments
Press
You can use the configuration menu functions to adjust setting such as brightness, contrast
and colour.
Turning the Projector Off
1
Turn off the power for all sources connected to
the projector.
2
Press
twice to turn off the power.
The Power indicator will flash orange (cool-down in
progress/about 20 seconds).
If a message prompting you to clean or replace the air
filter appears, follow the instructions in the message.
3
When the cool-down is complete, a "pip-pip"
confirmation buzzer will sound, and the Power
indicator will change to light orange.
Front adjustable foot
on the projector's control panel.
User's Guide "Using the Configuration Menu Functions"
on either the remote control or the projector to display the Configuration menu.
User's Guide
"Adjusting the Screen Image"
Adjusting the image
size and focus
Fine adjustments to
image size
Turn the zoom ring to adjust the
image size.
Turn to the "W" side to increase
the image size, and turn to the "T"
side to reduce the image size.
Adjusting the focus
Turn the focus ring to adjust the
focus.
User's Guide
"Turning Off the Projector"
Power indicator
Operating problems may occur
if the power cable is
disconnected while the Power
indicator is flashing orange.