Cisco 2500 Series Panduan Konfigurasi - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Router Jaringan Cisco 2500 Series. Cisco 2500 Series 19 halaman. Wireless controller
Juga untuk Cisco 2500 Series: Panduan Instalasi (12 halaman), Panduan Penyebaran (23 halaman), Panduan Konfigurasi (50 halaman), Panduan Memulai (47 halaman)
Halaman Cetak
Configuring the Access Server
This functionality is coordinated by your system administrator at the site where the TCP/IP
host is located. You should not attempt to use AutoInstall unless the required files have been
provided on the TCP/IP host. See the publication Access and Communication Server
Configuration Guide for information on how AutoInstall works.
Take the following steps to prepare your access server for the AutoInstall process:
Step 1
Step 2
Step 3
Configuring the Access Server Manually Using the Setup Facility
If you do not plan to use AutoInstall, do not connect the access server's serial (WAN) cable
to the channel service unit/data service unit (CSU/DSU). This will prevent the access server
from attempting to run the AutoInstall process. The access server will attempt to run
AutoInstall whenever you start it if the serial (WAN) connection is connected on both ends
and the access server does not have a configuration stored in NVRAM. It can take several
minutes for the access server to determine that AutoInstall is not set up to a remote TCP/IP
host.
4-8 Cisco 2500 Series Access Server User Guide
Attach the synchronous serial cable to the access server.
Turn on power to the access server.
The access server will load the operating system image from Flash memory. If the
remote end of the WAN connection is connected and properly configured, the
AutoInstall process will begin.
If the AutoInstall completed successfully, you may wish to write the configuration
data to the access server's nonvolatile random-access memory (NVRAM).
Perform the following step to complete this task:
At the # prompt, enter the copy running-config startup-config command if you
are running Cisco IOS Release 11.0 or later, or the write memory command if you
are running a Cisco IOS release earlier than 11.0:
Hostname# copy running-config startup-config
Taking this step will save the configuration settings that the AutoInstall process
created in the access server. If you fail to do this, your configuration will be lost
the next time you reload the access server.