Epson EMP-715 - XGA LCD Projector Informasi Produk - Halaman 10
Jelajahi secara online atau unduh pdf Informasi Produk untuk Proyektor Epson EMP-715 - XGA LCD Projector. Epson EMP-715 - XGA LCD Projector 13 halaman. Epson powerlite 505c: product information
Juga untuk Epson EMP-715 - XGA LCD Projector: Spesifikasi (3 halaman)
Halaman CetakEPSON PowerLite 505c/715c Projector
Replacing the Lamp
The projection lamp typically lasts for about 1000 hours of
use. It is time to replace the lamp when you see the following:
❏ The projected image gets darker or starts to deteriorate.
❏ The
lamp warning light on top of the projector is red,
flashing red, or orange.
❏ The message
LAMP REPLACE
the lamp comes on (after about 900 hours of use). To
maintain projector brightness and image quality, replace the
lamp as soon as possible.
Warning: Let the lamp cool before replacing it. Also, do not touch
the glass portion of the lamp assembly. Touching the glass portion
of the lamp will result in premature lamp failure.
Contact your dealer or call EPSON at (800) 873-7766 in the
United States and Canada for a replacement lamp. Request
ELPLP14.
part number
Follow these steps to replace the lamp:
1. Turn off the projector, then unplug the power cord.
2. Allow the projector to cool down for at least half an hour (if
it has been on).
Warning: If the lamp breaks, handle the shards carefully to
avoid injury.
3. Turn the projector upside-down to access the lamp
compartment.
4. Use a screwdriver to loosen the retaining screw on the lamp
cover. (You can't remove the screw from the cover.)
When the screw is loose, lift off the lamp cover.
)
5. Use a screwdriver to loosen the two screws holding the lamp
in place. (You can't remove these screws.)
EPSON PowerLite 505c/715c Projector
10 -
appears on the screen when
6. Lift up the wire handle, as shown, and pull the lamp straight
out.
7. Gently insert the new lamp.
8. Once the lamp is fully inserted, tighten its screws.
9. Replace the lamp cover and tighten its screw securely. (The
projector won't come on if the lamp cover is loose.)
1/01
handle