Cisco 2525 Panduan Konfigurasi - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Router Jaringan Cisco 2525. Cisco 2525 23 halaman. Troubleshooting guide
Juga untuk Cisco 2525: Panduan Konfigurasi (23 halaman), Ikhtisar (10 halaman), Mempersiapkan Pemasangan (19 halaman), Panduan Pemecahan Masalah (4 halaman)

Take the following steps to configure the fractional T1/T1 DSU/CSU WAN module for a

typical leased-line connection, substituting the correct addresses and host names as

appropriate for your network:

Enter enable mode:

Step 1

Router> enable

password: enablepassword

Enter configuration mode:

Step 2

Router# config term

Router(config)#

Assign an IP address to the serial port on the module:

Step 3

Router(config)# interface serial port_number

Router(config-if)# ip address ipaddress subnetmask

Router(config-if)# no keepalive

Enter the framing type and line code type, substituting framing_type with sf

Step 4

(Superframe) or esf (Extended Superframe) and linecode_type with ami (alternate

mark inversion) or b8zs (bipolar eight zero substitution):

Router(config-if)# service-module t1 framing framing_type

Router(config-if)# service-module t1 linecode linecode_type

If you are using fractional T1 service, enter the time slot range and speed. In the

Step 5

following example, the time slot range is from 1 to 20 and the speed is 64-kbps:

Router(config-if)# service-module t1 timeslots 1-20 speed 64

Return to user EXEC mode:

Step 6

Router(config-if)# exit

Router(config)# exit

Router# exit

Router>

Configuring the Cisco 2524 and Cisco 2525 Routers 4-19

Configuring the Router