Cisco 2610XM Konfigurasi - Halaman 7

Jelajahi secara online atau unduh pdf Konfigurasi untuk Router Jaringan Cisco 2610XM. Cisco 2610XM 15 halaman. User guide

1.4 Configuration System (Setup)

In privileged EXEC mode you can setup the whole system, for example setup network

cards, put IP addresses, start simple RIP routing.

Router#setup

In Cisco routers interfaces are named as FastEthernet0/0 and FastEthernet0/1. Some of

our lab routers also include serial cable interfaces. Numbering is same like above.

If you don't like to put IP address like in 1.4 Configuration System (Setup), you can put

them with the following instructions.

In privileged EXEC mode give the next command:

Router#config terminal

Then enter the interface type port to enter the interface configuration mode.

Router(config)#interface FastEthernet0/0

Now you are in interface configuration mode and you can modify this chosen interface.

Enter the IP address and subnet mask of the interface using ip address ipaddress

subnetmask command.

Router(config-if)#ip address 10.12.0.1 255.255.255.252

In this mode you can give parameters like for example hello protocol interval in OSPF

for an interface. Exit interface configuration mode by giving command Ctrl-Z.