Cisco 2691 Series Panduan Memulai Cepat - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Router Jaringan Cisco 2691 Series. Cisco 2691 Series 29 halaman. Modular routers
Juga untuk Cisco 2691 Series: Menginstal dan Memformat (34 halaman), Lembar data (8 halaman), Panduan Pengguna (48 halaman)
Halaman Cetak
Warning
The illustration shows the DC power supply terminal block. Wire the DC power supply as illustrated. The proper
wiring sequence is ground to ground, positive to positive, and negative to negative. The ground wire should always
be connected first and disconnected last. Statement 239
Warning
An exposed wire lead from a DC-input power source can conduct harmful levels of electricity. Be sure that no
exposed portion of the DC-input power source wire extends from the terminal block plug. Statement 122
Do not overtorque the terminal block contact screws. Recommended torque is 8.0 ± 0.5 in-lb (0.9 ± 0.05 N-m).
Caution
Figure 8
DC Power Connections
Negative DC output
+
+
A
B
Install the plastic covers over the terminal block. (See Figure 9.)
Step 5
Step 6
Secure the wires using cable ties as shown in Figure 9. The chassis has a cable-tie attachment below and to the right of
the terminal block.
Turn on power to the DC circuit.
Step 7
Figure 9
Wire Routing and Attachment
SE E M AN
UA L BE FO
D S U
R E IN ST
AL LA TI O
56 K
N
Plastic covers
Connecting Routers to the Cisco Redundant Power System
If your router uses the Cisco Redundant Power System (RPS), refer to the Cisco RPS Hardware Installation Guide for
instructions about the power connections. To locate these documents, see the "Where to Go Next" section on page 23.
Terminal
block
-DC, input B
Return, input B
Safety ground
Return, input A
-DC, input A
Cable tie
SE E M AN
UA L BE FO
R E IN ST
AL LA TI O
N
Positive DC input
+
+
A
B
Return, input B
+DC, input B
Safety ground
+DC, input A
Return, input A
From DC
power
source
Terminal
block
15