Ace 3003530 (AC-6168) Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori Ace 3003530 (AC-6168). Ace 3003530 (AC-6168) 8 halaman. Wireless door sensor chime

Halaman Cetak

Important considerations: The sensor/transmitter must be mounted to the

door jamb. The magnet should be attached to the door. To prevent vandalism

and increase battery life, the sensor/transmitter should be installed inside.

Install an alkaline type A23 12 Volt battery. The positive terminal should be

positioned as shown.

Alignment Marks

The edge of the magnet must be within 1/2" (13 mm) in. of the edge of the

transmitter, the alignment marks must be positioned as shown, and the front

surfaces of the magnet and transmitter should be as nearly flush with each

other as possible. It may be necessary to use the spacer under the magnet

to obtain the correct spacing.

Use either screws or double-sided tape to mount the magnet

and transmitter.

Installation

To install the battery in the transmit-

ter remove the back of the case

by pushing in the tab on the bot-

tom with a small screwdriver

and rotating the blade.

Test the location of the sensor/transmitter. Hold

the transmitter on the door jamb with one hand,

and the magnet with the other as shown. Take

the magnet away, and the chime should sound.

Attach the back of the case to the door jamb or wall. Snap

the front of the transmitter and magnet back on.

When attaching the magnet or transmitter

using the double-sided tape, make sure the

surface is clean.

-2-

598-1073-02