CAB 5314 Panduan Operator - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Operator untuk Pembuat label CAB 5314. CAB 5314 17 halaman. Vacuum-belt applicator
3
Operation
3.4
Power Supply of the Devices
1
Fig.6
Power supply of the applicator and printer
!
Attention!
The connected power cable delivers the full voltage to the printer module.
The switch on the applicator only provides power to the applicator.
1. Plug in the power supply cable (2) from the printer into power input module of the applicator.
2. Plug in connector (4) of the support cable (3) from applicator into power input module of the printer.
3. Switch on the applicator via the on switch (1).
4. Switch on the printer.
i
Note!
If only the printer and not the applicator is switched on the error message: Air pressure ins. will
appear.
5. For better cable guidance and organization use the four self-adhesive cable-clips (5) within the scope of the
delivery. These are freely applyable to suit the individual setup of the system.
3.5
Start Signal via External Sensor
The start signal for applying labels can be initiated by an external sensor that is connected to the 3-pin female
connector (1) directly on the applicator.
Fig.7
Connector for the starting sensor of the applicator
The start of the printing order is still initiated via the I/O interface of the printer.
To configure the external sensor see the above illustration and „4.3 Signals on page 14.
2
3
1
4
5
11