Cisco N540-FH-CSR-SYS Instal Manual - Halaman 31

Jelajahi secara online atau unduh pdf Instal Manual untuk Router Jaringan Cisco N540-FH-CSR-SYS. Cisco N540-FH-CSR-SYS 43 halaman.
Juga untuk Cisco N540-FH-CSR-SYS: Mempersiapkan Instalasi (14 halaman)

Halaman Cetak

Install the Device

Figure 33: Attach the AC Power Tie-and-Clip Cord

Note

These images are for only representation purposes. Certain variants of Cisco NCS 540 do not include a tie

for the power supply cord.

Activate an AC Power Supply Module

Perform the following procedure to activate an AC power supply:

Step 1

Plug the power cord into the power supply.

Step 2

Connect the other end of the power cord to an AC-input power source.

Step 3

Verify power supply operation by checking if the respective power supply front panel LED (PS0 or PS1) is green.

Step 4

If the LEDs indicate a power problem, see Troubleshooting for troubleshooting information.

Step 5

If you are also connecting a redundant AC power supply, repeat these steps for the second power source.

Note

If you are connecting a redundant AC power supply, ensure that each power supply is connected to a separate

power source in order to prevent power loss in the event of a power failure.

Activate an AC Power Supply Module

Install the Device