Ace AL7000 Panduan Pengoperasian - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Peralatan Uji Ace AL7000. Ace AL7000 13 halaman.
Juga untuk Ace AL7000: Panduan Pengoperasian (4 halaman)

Halaman Cetak

Display Indications

Display

Meaning

BAT

The testing cannot be performed because the

battery is low.

CAL

The device should be calibrated (to maintain

measurement accuracy and sensor warranty).

Alternatively, the integrated sensor can be

replaced with a new sensor.

blow

This display appears after the start and at the

end of the countdown. The device is ready for

the breath test.

Flo

This display appears if you have blown

incorrectly or too weakly.

Out

If the device has not received a breath sample

or has not received a sufficient breath sample,

"Out" appears on the display and the device

switches itself off automatically. This also

happens after 1 minute if no use is made

during this time.

Change of the Sensor

1. Open the sensor cover with a suitable, non-sharp tool or with a fingernail.

2. Pull the sensor out of the housing with your fingers or a tool that is not too hard (tweezers).

3. Insert the new sensor into the housing with your fingers or a suitable tool. Make sure that the contacts on the

sensor are inserted into the contacts of the pedestal.

4. Close the sensor cover. If it is difficult to close the sensor cover, the sensor is not seated correctly. In this

case, repeat the insertion of the sensor. Sensors. The sensor is also not seated correctly if "Err 2" appears on

the display after the next switch-on. Repeat the insertion of the sensor.

Action

Replace with new batteries.

Switch the unit on again and blow

vigorously, constantly and long enough into

the mouthpiece or mouthpiece opening

(depending on the mode selected). It is best

to blow as if you were whistling without sound.

Start blowing evenly into the previously

attached mouthpiece for 4 seconds. When

the beep stops and a click tone and a double

beep tone can be heard, the test is finished.

Press the start button, the countdown will start

again and "BLOW" will appear on the display.

You can now perform a new test.

Press power button to restart the countdown

cycle and retest.

Calibration

To maintain the accuracy of the breathalyzer, ACE Instruments recommends a calibration after 300 tests or

approx. every 6-12 months (depending which incident happens first). For a calibration service you can send

the device to ACE Instruments (see www.alkomat.net). The calibration is not mandatory, but the accuracy of the

breathalyzer will decrease steadily and additionally the warranty for the sensor expires.

We recommend sending it as a parcel, so that in case of loss an inquiry or proof of delivery is possible.

Battery Notices

The device associated with this operating manual contains 2 AA Alkaline batteries (1.5 V). These batteries

are non-rechargeable. The use of a rechargeable battery is not possible with this device and can damage

it. If the included batteries are depleted, they must not be thrown away into household waste. Used batteries

may contain harmful substances that can cause damage to the environment or your health. Please return all

depleted batteries to electrical appliance stores, who collect them for free.

Battery Exchange

To replace the batteries, push the battery cover on the rear of the unit downwards and replace the discharged

batteries with new ones. Be aware of the polarity when inserting the batteries (+/- pole). Close the battery

compartment cover again. In the EU, the return of used batteries is mandatory by law. All depleted and

rechargeable batteries will be recycled. This way valuable resources like iron, zinc and nickel can be retrieved

and reused. Battery recycling is the easiest lesson in environmental protection – so please support it!

The shown garbage bins mean that batteries or rechargeable batteries must not be thrown into the household

waste. The signs below the garbage bins are acronyms for the chemical substances inside the battery:

Hg: Battery contains Mercury

Cd: Battery contains Cadmium

Pb: Battery contains Lead