CAB HS Series Panduan Operator - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Operator untuk Pembuat label CAB HS Series. CAB HS Series 18 halaman. Label dispenser

Halaman Cetak
10
3

Loading Material

3.1 Loading Labels

1
2
3
8
Fig. 6
1. Turn ring (7) counterclockwise, so that the arrows points to the symbol
and thus release the margin stop (6) from the roll retainer (5).
2. Load label roll (4) on the roll retainer (5) in such a way that the labels are
visible from above at HS 120 / from below at VS 120.
3. Re-mount the margin stop (6) and push against the label roll as far as
possible.
4. Turn ring (7) clockwise, so that the arrow points to the symbol
fix the margin stop (6) on the roll retainer (5).
5. Swing away the brake (3).
6. Remove the labels manually from the label strip on the first 20 cm.
7. Guide label strip over the dispense plate (1) to the rewinder (9) as shown
in figure 6. The broken line shows the path for inside wound labels.
8. Hold rewinder (9) firmly and turn knob (8) clockwise until it stops.
9. Push liner under a bracket (2) of the rewinder (9) and turn knob (8)
counterclockwise until it stops.
The rewinder is fully spread, thus gripping the liner firmly.
10. Swing the brake (3) against the label strip.
11. Adjust the present sensor..
HS / HS+
4
5
6 7
9
Loading labels
VS / VS+
1
3
2
8
9
10
4
5
6 7
,
, and thus