Cisco NCS 6008 Manual - Halaman 7
Jelajahi secara online atau unduh pdf Manual untuk Router Jaringan Cisco NCS 6008. Cisco NCS 6008 12 halaman. 6000 series network convergence system routers unpacking, moving, and securing guide
Juga untuk Cisco NCS 6008: Membongkar, Memindahkan, dan Mengamankan Manual (44 halaman)
Halaman Cetak
Bring-up the Cisco NCS 6008 Router
What to do next
Connect to the management port to the ethernet network. See
on page
Connecting to the XR VM Management Port
The XR VM management port supports 10/100G optical small form-factor pluggable (SFP) units to provide
high speed network connectivity. The SFPs that can be connected to the XR VM management port are:
SFP module
Cisco SFP-10G-SR
Cisco SFP-10G-LR
1000BASE-SX SFP
1000BASE-LX/LH SFP
1000BASE-T SFP
Before you begin
Configure the management port. See
Step 1
Connect the SFP module to the XR VM management port.
The XR VM management port on the RP is shown in this figure.
RJ-45 port is disabled by default. Do not use the RJ-45 port. Use only the 1G copper SFP port as showm in the
Note
image below.
Figure 2: XR VM console port of the RP
Step 2
Depending on the SFP module type, connect either a optical fiber or an ethernet cable to the SFP.
What to do next
With a terminal emulation program, establish a SSH or telnet connection to the management interface port
using its IP address. For details on configuring the IP address of the management port, see
VM Management Port, on page
Before establishing a telnet session, use the telnet ipv4|ipv6 server max-servers command in the XR Config
mode, to set number of allowable telnet sessions to the router.
7.
Datasheet
http://www.cisco.com/en/US/prod/collateral/modules/ps5455/data_sheet_
c78-455693.html
http://www.cisco.com/en/US/prod/collateral/modules/ps5455/ps6577/product_
data_sheet0900aecd8033f885.html
5.
Connecting to the XR VM Management Port,
Configure the XR VM Management Port, on page
Bring-up the Cisco NCS 6008 Router
Connecting to the XR VM Management Port
5.
Configure the XR
7