CAB WICON SQUIX Panduan Servis - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Servis untuk Peralatan Industri CAB WICON SQUIX. CAB WICON SQUIX 18 halaman. Wrap-around applicator

Replacing Assembly Units

3.5

Replacing the Belt

Fig. 9

Replacing the belt

 Remove side cover, centering panel and guard plate at the gear side

 Pull the belt (1) from the gear wheels (2-6).

 Push the new belt onto the gear wheels.

Fig. 10

Tensioning the belt

 Check the tension of the belt.

Pluck the belt at the marked point (1) and measure the frequency of the oscillation withe a belt tension measuring

device.

Set value: f = 200...250 Hz

 If the result is out of the set value range, loosen for screws (7), tension the belt by pressing against the gear wheel

(5) on the motor (8) and re-tighten the screws (7).

 Repeat the measurement.

 Mount guard plate, centering panel and cover.

5 8