Cisco RV120W Panduan Memulai Cepat - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Router Jaringan Cisco RV120W. Cisco RV120W 21 halaman. Factory reset and reboot
Juga untuk Cisco RV120W: Panduan Memulai Cepat (2 halaman), Manual (2 halaman)

Halaman Cetak

1. Connecting the Equipment

Mounting the Cisco RV 120W

You can place your Cisco RV 120W on a desktop or mount it on a wall.

Installation Guidelines

• Ambient Temperature—To prevent the device from overheating, do

not operate it in an area that exceeds an ambient temperature of

104°F (40°C).

• Air Flow—Be sure that there is adequate air flow around the device.

• Mechanical Loading—Be sure that the device is level and stable to

avoid any hazardous conditions.

For desktop placement, place the Cisco RV 120W unit horizontally on a flat

surface so that it sits on its four rubber feet.

Wall Mounting

Determine where you want to mount the unit and install two screws

TEP

(not supplied) that are 2-7/16 in. apart (approximately 61 mm).

Mounting screws should have a head that is approximately 5.5 mm

in diameter and 2 mm deep, with a shaft that is at least 15.5 mm long

and approximately 3.5 mm wide. (Depending on your mounting

surface, you might require shorter or longer screws, or drywall

anchors.)

Do not mount the screw heads flush with the wall; the screw heads

must fit inside the back of the unit.

With the back panel pointing up (if installing vertically), line up the

TEP

unit so that the wall-mount slots on the bottom of the unit line up

with the two screws.

Cisco Small Business RV 120W Quick Start Guide

Wall

mount

slots

2-7/16