CAB ER4/210 Panduan Operator - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Operator untuk Aksesori Printer CAB ER4/210. CAB ER4/210 14 halaman. External rewinder
Juga untuk CAB ER4/210: Panduan Operator (14 halaman)

Halaman Cetak
CAB ER4/210 Panduan Operator
5
Operation
5.3

Rewinding onto 76 mm (3 in) Cardboard Core

i
Notice!
First remove the spring from the rewind axle!
Consider that the cardboard core (3) should be about 1 mm (0.04 in) broader than the label strip.
Warning!
!
Risk of injury by rotating engine parts.
When switching on the Rewinder starts immediately and winds to the material is tightened.
1
2
3
2
3 4
1
4
3
Figure 9
Rewinding onto 76 mm
(3 in) cardboard core
(drawing below without plate)
5
6
7
8
9
1. Put the first rewind adapter (3) onto the rewind axle (4) and
slide it up to the disc (1) until it stops. Make sure that the
knurled screw (2) of the rewind adapter is led in the groove
of the rewind axle. Tighten the knurled screw (2).
2. Put the second rewind adapter (3) onto the rewind axle
(4) and slide it towards the first adapter until the clearance
between the outer edge of it and the disc (1) is a little less
than the width of the cardboard core. Tighten the knurled
screw (2).
i
Notice!
Consider the required direction of rewinding :
- The broken line is valid for inside wound labels.
- The full line is valid for outside wound labels.
3. Put the cardboard core (5) on the rewind axle (2).
4. Feed the label strip over the guide axle (9) and under the
roller (8) up to the cardboard core (5).
5. Affix the end of the label strip with consideration of the
selected rewinding direction to the cardboard core using
adhesive tape or label.
6. Slide the plate (7) with the knurled screw outward onto the
rewind axle until it stops.
7. Tighten the knurled screw (6) on the plate.
8. Switch on the rewinder on the power switch.
13