CAB ST4/L Panduan Operator - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Operator untuk Aksesori Printer CAB ST4/L. CAB ST4/L 16 halaman. Stacker with cutter

Halaman Cetak

Printer Configuration

Once the stacker is connected to the printer, the printer will automatically recognize it on turn on.

The printer can be configured to suit the individual requirements of cut mode in the „Setup" menu. When the stacker

is installed, the „Cutter" menu will appear.

Note!

For detailed instructions for configuration  Configuration Manual of the printer.

For setting the cutter parameters select

-> Machine param.

Setup

Parameter

Cutter

> Cut

position

Table 2

Note!

The values of the setup are basic settings for the actual combination printer-stacker w/cutter. After changing

the stacker or printer a re-adjustment may be necessary.

Changes required for processing different print jobs should be implemented additional offsets available in

the software.

The offset values from setup and software are added together for execution.

Under Setup

when using cut mode can be selected.

Parameter

Label

sensor

Backfeed

Table 3

-> Cutter

Meaning

Configuration of the cutter

Offset of the cut position relative to the printed image

Cut position with the initial offset value of "0" causes to cut in the

middle of the gap between two labels.

If the cut position value is positive, the media will be advanced before it

is cut, that means the distance between the cut edge and the rear edge

of the label increases.

Cutter parameters

-> Print parameters

Meaning

Method for detecting the starting end of the label.

Gap Sensor: Detection using changes in the transparency between the

label and label gap.

Bottom-Reflect: Detection using reflex marks on the bottom of the

medium.

Continuos media: Synchronization of the paper feed when using

endless media in cutting mode.

 After loading media press the feed key.

That way a short feed and a synchronization cut are realized.

Method for backfeeding the material.

Backfeeding is necessary in the cutting mode since the front edge of a

second section already passes the print line when the first label is moved

to the cut position.

always: Backfeeding occurs independently of print contents.

smart: Backfeeding only occurs when the print contents of the next

section is not yet fully prepared when cutting the current section.

Otherwise, the second section is pushed on and completed after removal

of the first section without backfeeding.

Print parameters

the method for recognizing the material and the method of backfeed

Default

Gap sensor

smart