Cisco 1004-CH - 1004 Enet/ISDN/Bri Rter Panduan Penyebaran - Halaman 32

Jelajahi secara online atau unduh pdf Panduan Penyebaran untuk Titik Akses Nirkabel Cisco 1004-CH - 1004 Enet/ISDN/Bri Rter. Cisco 1004-CH - 1004 Enet/ISDN/Bri Rter 40 halaman. Lightweight access points

Cisco 1004-CH - 1004 Enet/ISDN/Bri Rter Panduan Penyebaran

Optional Minimal Site Survey

Placing Access Points

The final step is to determine the installation location of the access point. First, using the radius or Z
factor found in Step A, distribute the circles or squares evenly across the rectangles found in Step B.
Note that the large "X" in the middle of each coverage area indicates the approximate location of the
Cisco 1000 series lightweight access points. Also notice that the Z factor between the centers of each
Cisco 1000 series lightweight access point location is the same as the Cisco 1000 series lightweight
access point squares when the squares are directly adjacent to each other, as shown in this figure.
Figure 6
Optional Minimal Site Survey
If the
assumptions.
The minimal site survey consists of the following:
Deployment Guide: Cisco Aironet 1000 Series Lightweight Access Points
14
Access Points Location
"Building
Type" or RF characteristics assumptions are in doubt, complete this step to verify those
Collecting Tools and Materials
Selecting Cisco 1000 Series Lightweight Access Point Locations
Preparing Optional Cisco 1000 Series Lightweight Access Point Tripod Test Assemblies
Positioning a Cisco 1000 Series Lightweight Access Point at Each Planned Location
Verifying RF Coverage Using the Site Survey Tool
Deployment
78-17279-01