Cisco 1700 series Panduan Konfigurasi

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Titik Akses Nirkabel Cisco 1700 series. Cisco 1700 series 25 halaman. Secure firewall management center
Juga untuk Cisco 1700 series: Panduan Informasi Kepatuhan Peraturan dan Keselamatan (45 halaman), Manual (15 halaman), Catatan Aplikasi (41 halaman), Pemecahan Masalah Perangkat Keras (12 halaman), Panduan Ikhtisar (13 halaman), Mengkonfigurasi (34 halaman), Manual (5 halaman), Panduan Memulai Cepat (6 halaman), Panduan Pemasangan Perangkat Keras (46 halaman)

Configuring a Single-Port Ethernet WIC on a

Cisco 1700 Series Router

The Cisco WIC-1ENET is a single-port Ethernet interface card supporting 10BASE-T Ethernet. The

card provides the Cisco 1700 series router with additional Ethernet interfaces.

Figure 1

shows the Cisco WIC-1ENET interface card.

Figure 1

Cisco WIC-1ENET Interface Card

S E E M A N

U A L

B E F O R E

IN S T A L L

A T IO N

The LNK (physical layer link) LED is on when the IOS recognizes the Cisco WIC-1ENET card and the

connection is up. The FDX LED is on when the port is operating in full-duplex mode, and off when

operating in half-duplex mode. Additionally, the Activity LED on the front of the Cisco 1700 series

router indicates that data is transmitted or received on the slot.

Note

The Cisco 1700 Router Hardware Installation Guide provides procedures for physical installation.

Although those instructions are for a WAN interface card (WIC), the procedures also apply to installing

this card.

This document contains the following sections:

Cisco WIC-1ENET Requirements

•

IOS Commands

•

Caveats

•