Cisco 1830 Series Panduan Memulai - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Titik Akses Nirkabel Cisco 1830 Series. Cisco 1830 Series 44 halaman.

Figure 3

Pre-Installation Configuration Setup

To perform pre-installation configuration, perform the following steps:

Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use

Step 1

the CLI, web-browser interface, or Cisco Prime Infrastructure procedures as described in the

appropriate Cisco wireless LAN controller guide.

a. Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller

Management and AP-Manager Interface.

b. Configure the switch to which your access point is to attach. See the Cisco Wireless LAN

Controller Configuration Guide for the release you are using, for additional information.

c. Set the Cisco wireless LAN controller as the master so that new access points always join with

it.

d. Make sure DHCP is enabled on the network. The access point must receive its IP address

through DHCP.

e. CAPWAP UDP ports must not be blocked in the network.

f. The access point must be able to find the IP address of the controller. This can be

accomplished using DHCP, DNS, or IP subnet broadcast. This guide describes the DHCP

method to convey the controller IP address. For other methods, refer to the product

documentation. See also the

Controller

Layer 3

devices

Cisco wireless

access points

"Configuring DHCP Option 43" section on page 26

for more