Cisco 2800 Series Konfigurasi - Halaman 8

Jelajahi secara online atau unduh pdf Konfigurasi untuk Titik Akses Nirkabel Cisco 2800 Series. Cisco 2800 Series 10 halaman. Cisco ios software configuration
Juga untuk Cisco 2800 Series: Panduan Memulai Cepat (13 halaman), Lembar data (8 halaman), Panduan Memulai Cepat (47 halaman), Catatan Aplikasi (41 halaman), Panduan Memulai Cepat (45 halaman), Ikhtisar (27 halaman), Lembar data (5 halaman), Lembar data (20 halaman), Mengkonfigurasi (32 halaman)

Cisco 2800 Series Konfigurasi
Configuring the Router
Initial Configuration Using the Cisco CLI—Manual Configuration
This section shows how to display a command-line interface (CLI) prompt for configuration using the
CLI, and it directs you to documentation for the CLI configuration.You can use the CLI if you see the
following messages at the end of the startup sequence:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
If these messages do not appear, SDM and a default configuration file were installed on the router at the
factory. To use SDM to configure your router, see the
Security Device Manager" section on page
For help with interface and port numbering, refer to the
of Cisco 2800 Series Routers
To proceed with manual configuration using the CLI, enter no when the power-up messages end:
Step 1
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2
Press Return to terminate autoinstall and continue with manual configuration:
Would you like to terminate autoinstall? [yes] Return
Several messages are displayed, ending with a line similar to the following:
...
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled <date> <time> by <person>
Press Return to bring up the Router> prompt.
Step 3
...
flashfs[4]: Initialization complete.
Router>
Type enable to enter privileged EXEC mode:
Step 4
Router> enable
Router#
Step 5
For configuration procedures, refer to the online
documents.
Note
When you have finished the initial configuration, verify the initial configuration. See the
Step 6
Initial Configuration" section on page 9
Power Up and Initial Configuration Procedures for Cisco 2800 Series Routers
10
online document.
To avoid losing work you have completed, be sure to save your configuration occasionally as you
proceed. Use the copy running-config startup-config command to save the configuration to
NVRAM.
"Initial Configuration Using Cisco Router and
5.
"Interface Numbering"
Cisco 2800 Series Software Configuration Guide
for verification procedures.
section of the
Overview
"Verifying the
OL-5788-01