Cisco 500 Series Panduan Memulai Cepat - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Titik Akses Nirkabel Cisco 500 Series. Cisco 500 Series 25 halaman. Stackable managed switches
Juga untuk Cisco 500 Series: Manual Informasi Keselamatan (42 halaman), Manual (4 halaman), Mulai Cepat Quide (13 halaman), Panduan Memulai Cepat (21 halaman), Lembar data (5 halaman), Panduan Pengguna (4 halaman), Panduan Pengguna (6 halaman), Panduan Pengguna (46 halaman), Manual (40 halaman), Panduan Administrasi (48 halaman), Manual (24 halaman), Pemecahan Masalah dan Pemeliharaan (15 halaman), Panduan Referensi Cepat (7 halaman)

Halaman Cetak

Make sure that any configuration changes are saved before

AUTION

exiting by issuing the command:

copy running-config startup-config

You are ready to configure the switch. Refer to the

Stackable Managed Switch Administration Guide

If you are not using DHCP on your network, set the IP address type

OTE

on the switch to Static and change the static IP address and subnet

mask to match your network topology. Failure to do so may result in

multiple switches using the same factory default IP address of

192.168.1.254.

Stacking the Switches

Before configuring the switches as a stack, refer to the Cisco 500 Series

Stackable Managed Switch Administration Guide for additional details.

Refer to the front panel graphics in

Series Stackable Managed Switch

descriptions and supported modules.

The following graphic shows the stack ports to assist in connecting the

devices in a stack:

LINK

ACT

XG1

XG2

XG3

The 500X model is on the left, and the Sx500 model is on the right. The

SG500XG-8F8T model is shown below.

LINK

ACT

Cisco Small Business

XG4

/S1

/S2

Stack

for further information.

External Features of the Cisco 500

to help with the stack port

LINK/ACT GIGABIT

G25/S1

G26/S2

LINK

ACT

500 Series Stackable Managed Switches

Cisco 500 Series

Cisco Small Business

LINK

ACT

LINK

ACT

SFP

G27/S3

G28/S4

1G/5G

LINK/ACT

GIGABIT