Cisco 7200 VXR Series Panduan Memulai Cepat - Halaman 41
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Titik Akses Nirkabel Cisco 7200 VXR Series. Cisco 7200 VXR Series 48 halaman. Preparing for installation
Juga untuk Cisco 7200 VXR Series: Lembar data (12 halaman), Manual (14 halaman)
Halaman Cetak
To connect a Cisco USB Flash memory module or the Aladdin USB eToken Pro key to the NPE-G2 USB port, simply insert the
module into the port as shown in Figure 23. The Flash memory module can be inserted in only one way, and can be inserted or
removed regardless of whether the router is powered up or not.
Caution
Do not remove a USB Flash memory module when a read or write operation to the USB Flash memory module is
in progress. The router might reload, or the USB Flash memory module card can be damaged.
Note
Only Cisco USB Flash memory modules and the Aladdin USB eToken Pro key are supported by Cisco routers.
Note
For detailed information about the Cisco IOS commands that support USB Flash memory modules, see the document
Cisco IOS USB Flash Module and USB eToken
Replace a Port Adapter or Service Adapter
Figure 24
Replacing a Port Adapter
ETHERNET 10BT
Cisco 7200
Series
1
Port adapter in place
2
Port adapter lever in unlocked position
3
Port adapter partially removed or installed
Note
Before removing a port adapter, shut down the interface so that there is no traffic running through the port adapter
when it is removed.
Step 1
To remove a port adapter, place the port adapter lever in the unlocked position (2).
Note
If you have difficulty installing a processing engine or I/O controller in the lowest slot of a Cisco 7200 VXR
router that is rack-mounted, remove the port adapters, processing engine and I/O controller from the chassis
and reinstall them. Install the processing engine and I/O controller in the lowest slots first, then populate the
slots above them, in a bottom-to-top order.
Step 2
Grasp the handle and pull the port adapter from the router, about halfway out of its slot (3). If you are removing a
blank port adapter, pull the blank port adapter completely out of the chassis slot.
Step 3
With the port adapter halfway out of the slot, disconnect all cables from the port adapter. After disconnecting the
cables, pull the port adapter from its chassis slot.
5
TOKEN RING
FAST ETHERNET INPUT/OUTPUT CONTROLLER
1
2
Support.
4
Cisco 7200
Series
4
Slot guide
5
Port adapter lever in locked position
TOKEN RING
ETHERNET 10BT
FAST ETHERNET INPUT/OUTPUT CONTROLLER
3
41