Cisco AIR-AP1042N-A-K9 Panduan Memulai - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Titik Akses Nirkabel Cisco AIR-AP1042N-A-K9. Cisco AIR-AP1042N-A-K9 35 halaman.

Halaman Cetak
Cisco AIR-AP1042N-A-K9 Panduan Memulai

Pre-Installation Configuration Setup

Figure 2 shows the pre-installation configuration setup.
Figure 2
Pre-Installation Configuration Setup
Follow these steps to perform the pre-installation configuration.
Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use
Step 1
the CLI, web-browser interface, or Cisco WCS procedures as described in the appropriate
Cisco wireless LAN controller guide.
a. Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller
Management and AP-Manager Interface.
b. Configure the switch to which your access point is to attach. See the Cisco Unified Wireless
Network WLAN Controller Guide: Cisco 440x Series WLAN Controllers for additional
information.
c. Set the Cisco wireless LAN controller as the master so that new access points always join with
it.
d. Make sure DHCP is enabled on the network. The access point must receive its IP address
through DHCP.
Controller
Layer 3
devices
Cisco Aironet
access points
9