Cisco AIR-AP2802I-B-K9 Panduan Memulai - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Titik Akses Nirkabel Cisco AIR-AP2802I-B-K9. Cisco AIR-AP2802I-B-K9 50 halaman.

documentation. See also the

information.

The access point requires a gigabit Ethernet (GbE) link to prevent the Ethernet port from

Note

becoming a bottleneck for traffic because wireless traffic speeds exceed transmit speeds

of a 10/100 Ethernet port.

Apply power to the access point. See

Step 2

a. As the access point attempts to connect to the controller, the LEDs cycle through a green, red,

and amber sequence, which can take up to 5 minutes.

If the access point remains in this mode for more than five minutes, the access point is

Note

unable to find the Master Cisco wireless LAN controller. Check the connection between

the access point and the Cisco wireless LAN controller and be sure that they are on the

same subnet.

b. If the access point shuts down, check the power source.

c. After the access point finds the Cisco wireless LAN controller, it attempts to download the

new operating system code if the access point code version differs from the Cisco wireless

LAN controller code version. While this is happening, the Status LED blinks amber.

d. If the operating system download is successful, the access point reboots.

Configure the access point if required. Use the controller CLI, controller GUI, or Cisco Prime

Step 3

Infrastructure to customize the access-point-specific 802.11ac network settings.

If the pre-installation configuration is successful, the Status LED is green indicating normal

Step 4

operation. Disconnect the access point and mount it at the location at which you intend to

deploy it on the wireless network.

If your access point does not indicate normal operation, turn it off and repeat the

Step 5

pre-installation configuration.

"Configuring DHCP Option 43" section on page 28

Powering the Access Point, page

for more

21.