DigitaLinx DL-AS21C Panduan Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Beralih DigitaLinx DL-AS21C. DigitaLinx DL-AS21C 9 halaman.

To enable automatic switching, slide the Switch mode selector switch to the Auto

position. When in auto-switch mode, the DL-AS21C will switch according to the

following rules:

New Input: Upon detecting a new input, the switcher will automatically select the new

input.

Reboot: Once power is restored to the switcher, it will automatically reconnect the

active input. If both inputs are active, it will switch to the VGA input.

Source Removed: When an active source is removed, the DL-AS21C will switch to the

first available active input.

To enable manual switching, slide the Switch mode selector switch to the Man position.

When in manual switch mode, the select the input of the DL-AS21C by using one of the

following methods:

Front Panel: Press either the HDMI or VGA buttons.

Contact Closure: Make a contact closure between the HDMI and GND contacts or the

VGA and ground contacts.

RS232: Transmit the

Automatic display on:

To automatically turn on the display when an active input is connected, slide the CEC

mode switch to the Auto position. When in Auto mode, the DL-AS21C will turn on the

display once an active source has been connected.

Automatic display off:

To automatically turn off the display when no active input is connected, slide the CEC

mode switch to the Auto position. When in Auto mode, the DL-AS21C will turn off the

display after no sources have been connected for three (3) minutes. To increase the

time before power off, send the

Manual display on/off:

To manually turn on or off the display, slide the CEC mode switch to the Man position.

When in Man mode, the DL-AS21C can turn on and off the display with active sources

connected to the inputs.

Front Panel: Press either the ON or OFF buttons.

Contact Closure: Make a contact closure between the ON and GND contacts or the OFF

and ground contacts.

RS232: Transmit the

Input Selection

SET HDMI

SET VGA

CEC OFF XX

DISPLAY ON

DISPLAY OFF

RS232 commands.

command via RS232.

RS232 commands.