Cisco AP1010 Panduan Memulai Cepat - Halaman 22

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Titik Akses Nirkabel Cisco AP1010. Cisco AP1010 36 halaman. Aironet 1000 series ieee 802.11a/b/g lightweight access points with internal antennas

Halaman Cetak
Cisco AP1010 Panduan Memulai Cepat
Mounting the Access Points

Projection Wall Mount

When you are mounting the AP out from a wall (flat sides along the wall or hallway), use an optional
factory-orderable projection-mount L-bracket.
1.
The AP threaded holes have precision-depth threads. Do not overtighten the screws, or the bracket will
Note
not fit under the screw heads.
Figure 7
2.
3.
4.
Note
If the screws do not securely hold the bracket, remove the AP and adjust the screws until they securely
hold the bracket.
AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal
10
Before proceeding, gently screw the two factory-supplied screws and spring washers into the bottom
of the AP. Be sure the spring washers have their convex (high center sections) pointing toward the
screw heads.
Attaching the Mounting Screws and Spring Washers to the AP
A. Screws and spring washers
Copy the MAC address(es) from the label(s) on the AP onto the corresponding location on the map.
MAC addresses have the format 00xxxxxxxxxx.
You have already attached the projection-mount L-bracket to the wall in
Points".
Slide the screws into the keyhole slots on the mounting bracket as shown in the following figure.
Installation and Configuration
B. Completed assembly
"Mounting the Access
7817146-01