Epson Artisan 700 Series Panduan Instalasi Jaringan - Halaman 34

Jelajahi secara online atau unduh pdf Panduan Instalasi Jaringan untuk Semua dalam Satu Printer Epson Artisan 700 Series. Epson Artisan 700 Series 41 halaman. Using the control panel for wireless network installation
Juga untuk Epson Artisan 700 Series: Panduan Pengguna (11 halaman), Informasi Pengaturan Penting (3 halaman), Panduan Pengguna (34 halaman), Panduan Pengguna (38 halaman), Spesifikasi (2 halaman), Panduan Memulai Cepat (8 halaman), Buletin Dukungan Produk (5 halaman), Manual Fungsi (28 halaman), Faq (4 halaman)

Halaman Cetak

Epson Artisan 700 Series Panduan Instalasi Jaringan

Cannot communicate on a wired LAN

Make sure that the wireless setting on the printer's control panel is set to

Select

Setup

, and select

LAN Setup

communicate using a wired connection.

The printer does not appear in the Add Printer window (Mac OS X)

Make sure the printer driver was installed correctly and that your computer's

TCP/IP settings are configured correctly.

Printing Problems

Cannot print over the network

■

Print a Network Status Sheet (see page 36) and verify that the network

settings are correct.

■

Make sure that the printer is turned on, and that your router, access point,

switch, or hub's link LED for the port the printer is connected to is on or

flashing. If the link LED is off, try the following.

■

Make sure the Ethernet cable is securely connected to both the printer

and your router, access point, switch, or hub.

■

Try connecting to another port on your router, access point, switch, or

hub.

■

Try connecting the printer to another router, access point, switch or hub.

■

Try connecting the printer to your router, access point, switch, or hub

with another Ethernet cable.

■

When using TCP/IP, make sure the printer's IP address is set correctly for your

network. If your network does not assign IP addresses using DHCP, you will

need to set the IP address manually.

■

For wired connections, print a Network Status Sheet (see page 36). If the

Network Status says Disconnect, check your Ethernet cable connections and

try turning the printer off and back on again.

■

For wireless connections, print a Network Status Sheet (see page 36). If the

Link Status says Disconnect, make sure that the wireless router or access point

is turned on and that the settings are correct for your wireless network.

Troubleshooting

from the Home menu, select

Disable

Network Settings

. If it is set to

Enable

, choose

Wireless

, the printer will not

Disable