Epson Artisan 800 - All-in-One Printer Faq - Halaman 3

Jelajahi secara online atau unduh pdf Faq untuk Semua dalam Satu Printer Epson Artisan 800 - All-in-One Printer. Epson Artisan 800 - All-in-One Printer 4 halaman. Artisan 700/800 series
Juga untuk Epson Artisan 800 - All-in-One Printer: Panduan Instalasi Jaringan (41 halaman), Panduan Pengguna (34 halaman), Panduan Pengguna (38 halaman), Penggantian Kartrid (2 halaman), Spesifikasi (2 halaman), Panduan Memulai Cepat (8 halaman), Buletin Dukungan Produk (5 halaman), Panduan Instalasi Jaringan (29 halaman), Informasi Pengaturan (3 halaman)

Modifying the Case (not required) In order to get the tube

out of the printer you can either, allow the tubing to drop out

of, the open area and underneath the back of the printer or

widen the screw hole (the one you removed the screw from to

release the waste pad holder). If your printer is out of

warranty, I would recommend widening the hole to benefit

from the extra safety factor this Waste kit provides. The hole

needs to be widened to 4.5mm wide (as indicated in the

image, left)

Install the External Tube Part & Re-connect With the screw

hole widened you should now be able to insert the external

section of the Solo-X tube part and connect it to the internal

part as shown in the two images left and below.

Tubing connected... and an Explanation Now that you

have the tubing all connected you can gently pull the whole

extension back out until the connector joining the two

sections reaches the screw hole. The reason the connector is

there at all is to act as a safety strain relief. It provides a solid

stop point for the tubing so that the inner waste tube

(particularly the printers original waste tube) does not suffer

from an accidental pull, that could damage the whole waste

ink cleaning system. Only the outer tube part will be stretched

or yanked.

Install the Tube Guide The kit also comes with a tube guide

which you can use to ensure the Solo-X tube part does not

hang around or potentially catch in any of the gears exposed

within the Waste Pad area. The guide has two sticky pads

which you remove the backing paper from and then press into

position. It's best to put the guide on the tube, check position,

etc.. before removing the backing paper though. Note: To

ensure a good firm adhesion to the plastic, it's a good idea to

clean the area you intend to attach the guide using something

that doesn't leave a residue behind. Isopropyl Alcohol is best

but even a bit of tissue to remove any oils from your

hands/fingers is better than nothing.

3/4