Argo A1/SWAN Panduan Petunjuk Pengoperasian - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pendingin Udara Argo A1/SWAN. Argo A1/SWAN 13 halaman.

If used during summer, it is best to leave the flexible pipe attached so that the hot air is discharged towards

the outside rather than into the room.

During dehumidification, continuous drainage should be implemented (see the next chapter, "HOW TO ELIMINATE

CONDENSATE").

3. FAN MODE



Press the MODE button to select ventilation until the corresponding icon appears.



In this mode, the fan speed can be adjusted.



The temperature cannot be adjusted.

Manual drainage

Continuous drainage

V 12/16

HOW TO ELIMINATE CONDENSATE

Cooling

This appliance automatically vaporises condensate in the cooling mode.

Ensure that when the unit is operating in cooling mode, the rubber caps

closing the drainage holes on the rear of the appliance are properly

positioned.

When the air conditioner operates in cooling mode, there is no need for

continuous condensate drainage; only in specific weather conditions with very

high air humidity levels may water deposit inside the unit. When the container

is full, the "Full" LED (full tank) lights up on the control panel to signal that full

status and block the appliance's operation.

To empty the container, switch the air conditioner off and unplug it. Remove

the cap form the rear drainage hole and direct it over a normal drain.

Ensure that the tube is not twisted or bent. The tube must slope downwards.

Re-close the drainage hole with the cap and resume use of the air conditioner.

Dehumidification

WARNING!

When using the air conditioner in dehumidification mode, it is advisable to

always arrange for continuous drainage, so as to maximise dehumidification

efficiency.

Connect one end of the PVC pipe (not provided) to the upper discharge hole

and place the other end above a drain.