Cisco Meraki MR42E Panduan Instalasi - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Titik Akses Nirkabel Cisco Meraki MR42E. Cisco Meraki MR42E 15 halaman.

To release the MR42E from the mount cradle, first remove the security screw that secures the MR42E to the cradle's

bottom tab. While holding the MR42E with one hand, press the cradle's bottom tab upwards, releasing the MR42E from

the bottom of the cradle. Then remove the MR42E from the cradle's top tab.

Desk or Shelf Mount

The MR42E can be placed on a desk or shelf resting on the non-scratch rubber feet. The mount cradle is not necessary

for a desk or shelf installation.

Attach Antenna

The MR42E is certified for use with the following Meraki indoor antennas:

1. MA-ANT-3-A1/5 (1/5 stands for the quantity of the antennas)

2. MA-ANT-3-B1/5 (1/5 stands for the quantity of the antennas)

3. MA-ANT-3-C5 (5 stands for the number of ports for the antennas)

4. MA-ANT-3-D5 (5 stands for the number of ports for the antennas)

5. MA-ANT-3-E5 (5 stands for the number of ports for the antennas)

6. MA-ANT-3-F5 (5 stands for the number of ports for the antennas)

These antennas come with RP-TNC connectors compatible with the MR42E.

Connecting MA-ANT-3-A/B series antennas

The MA-ANT-3-A/B series antennas are dipole omnidirectional antennas that may be connected to any of the

antenna connectors on the MR42E, order is not important.

Connecting MA-ANT-3-C/D/E/F series antennas

The MA-ANT-3-C/D/E/F antennas will come with five antenna cables with RP-TNC connectors that connect into

the five antenna ports on top of the access point. Four antenna cables have a white jacket just above the RP-

TNC connector and should connect into the three 2.4/5 GHz antenna ports and one Scanning antenna port. One

of the antenna cables will have a grey jacket above the RP-TNC connector and should connect into the IoT

antenna port.

C/D/E/F series antennas will be automatically detected by the AP. Once an antenna is detected by the AP it

cannot be changed in dashboard until the antenna is removed and AP is rebooted.

It is important to ensure that all five antenna ports on the MR42E are connected to their respective antenna cables for

maximum performance and functionality.