Cisco Meraki MR52 Panduan Pemasangan Perangkat Keras - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Titik Akses Nirkabel Cisco Meraki MR52. Cisco Meraki MR52 25 halaman. Dual-band enterprise class 802.11ac wave 2 cloud-managed access point
Juga untuk Cisco Meraki MR52: Panduan Instalasi (17 halaman)
Halaman Cetak
3
Pre-Install Preparation
You should complete the following steps before going on-site to perform an installation.
3.1 Configure Your Network in Dashboard
The following is a brief overview only of the steps required to add an MR52 to your network. For detailed
instructions about creating, configuring and managing Meraki wireless networks, refer to the Meraki Cloud
Controller Manual (meraki.com/library/product).
1. Login to
http://dashboard.meraki.com.
2. Find the network to which you plan to add your APs or create a new network.
3. Add your APs to your network. You will need your Meraki order number (found on your invoice if you
ordered directly from Meraki) or the serial number of each AP, which looks like Qxxx-xxxx-xxxx, and is
found on the bottom of the unit. You will also need your Enterprise Cloud Controller license key, which you
should have received via email from [email protected].
4. Go to the map / floor plan view and place each AP on the map by clicking and dragging it to the location
where you plan to mount it.
3.2 Check and Upgrade Firmware
To ensure your MR52 performs optimally immediately following installation, Meraki recommends that you
facilitate a firmware upgrade prior to mounting your MR52.
1. Attach your MR52 to power and a wired Internet connection. See p. 19 of this Hardware Installation
Guide for details.
2. The MR52 will turn on and the Power LED will glow solid orange. If the unit does not require a firmware
upgrade, the Power LED will turn white within thirty seconds.
* If the unit requires an upgrade, the Power LED will begin blinking orange until the upgrade is complete,
at which point the Power LED will turn solid white. You should allow about an hour for the firmware
upgrade to complete, depending on the speed of your internet connection.
3.3 Check and Configure Firewall Settings
If a firewall is in place, it must allow outgoing connections on particular ports to particular IP addresses.
The most current list of outbound ports and IP addresses can be found here:
http://tinyurl.com/y79une3
8
If this is your first time, create a new account.