Digitaltech-Market EDIC-mini Tiny16+ Panduan Operasional - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Operasional untuk Perekam Suara Digitaltech-Market EDIC-mini Tiny16+. Digitaltech-Market EDIC-mini Tiny16+ 11 halaman. Dvr

Halaman Cetak
Trouble
symptoms
Faint LED is
permanently ON
When connecting
the recorder to the
PC the LED is
flashing frequentl
No flash of LED
on the recorder
after disconnecting
off the PC
10 flashes of LED
after enabling
recording
Recording starts at
the wrong time
Red and green
LEDs are not on
the adapter

Troubleshooting

Trouble
The recorder is
unresponsive to the
user's activity
The recorder is
unresponsive to the
user's activity - the
rechargeable
battery is
discharged
When
disconnecting off
the PC the recorder
won't go to Standby
Mode
When enabling
recoding, the
recorder won't
record
Malfunction of
timer
The recorder can't
be connected to the
PC
Possible solution
Replace the battery (for battery recorders)
Press the Reset button for 2 seconds or switch
off and then back on the recorder's power (for
rechargeable battery recorders)
Leave the recorder connected to the PC. After
some time depending on the battery discharge
level the PC will recognize a removable
media and the LED will be flashing gradually
with the interval of 5 seconds.
Remove and install battery again (for the
recorders with batteries).
Press the Reset button for 2-3 seconds (for the
recorders with rechargeable batteries).
Try to format the recorder in RecManager,
but remember the contents will be deleted
Recorder's clock may fail because:
1. Lost or switched off power
2. Recorder's time was not synchronized with
the PC time,
3. You forcedly enabled recording.
Synchronize the recorder's time with the PC.
In recorder settings untick «Time
synchronization with the PC». Adjust the
desirable timer and make record. After
connecting to the PC verify the time on the
recorder and the PC.
Forced connection is needed: set the switch to
ON position and press reset for rechargeable
battery recorders or insert battery for battery
ones. The LED must start flashing. Shift the
Switch to On position and connect to the PC.
11