Cisco WAP125 Panduan Memulai Cepat - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Titik Akses Nirkabel Cisco WAP125. Cisco WAP125 13 halaman. Wireless-ac/n dual band desktop access point with poe
Juga untuk Cisco WAP125: Manual (10 halaman), Panduan Memulai Cepat (14 halaman)
Halaman Cetak
If the Cisco WAP125 does not receive a DHCP response (there is no DHCP
server on your network) after 60 seconds, the Cisco WAP125 will fallback
to the following default static IP address: 192.168.1.245 and a default mask
of 255.255.255.0. To reach that IP address, be sure that your computer is
on the 192.168.1.xxx network.
Rebooting the Cisco WAP125 or Resetting
8
to Factory Defaults
To reboot your Cisco WAP125:
• If the Cisco WAP125 uses a power adapter, with the power on, use the
POWER button to reboot the device. The POWER button only functions
when the Cisco WAP125 uses a power adapter.
• If the power supply is PoE, unplug your Ethernet connection for three
seconds and plug it back in.
• With the power on, press the RESET button with an opened paper clip
for less than 10 seconds, or until the lights go off.
–
When all the lights go off, release the RESET button.
–
Release the RESET button as soon as the lights go off, or you will
restore the Cisco WAP125 to factory default settings and lose your
configurations.
To reset the Cisco WAP125 to factory default settings:
• With the power on, press and hold the RESET button with an opened
paper clip for more than 10 seconds.
–
All of the lights will go off.
–
Release the RESET button when the power light turns on.
Cisco WAP125 Quick Start Guide
9