digitalview HD-3000 Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Adaptor digitalview HD-3000. digitalview HD-3000 15 halaman. Hd/sd-sdi to hdmi adaptor board

Halaman Cetak

1. Introduction

The HD-3000 converts SD/HD-SDI (SD, HD and 3G) signal to HDMI for driving HDMI monitors. The HD-3000 provides re-clocked loop

through outputs for "daisy chaining" multiple monitors or other equipments to the same HD-SDI source. It also supports embedded

audio.

Fully compliant with the SMPTE 259M-C, SMPTE 292M, SMPTE 424M, 425M standards.

HD-3000 Key Features

a. Supports 1.5Gbits & 3Gbits bit rate input signal support.

The mode support is listed in page 11.

b. Dual channels input port supported.

HD-3000 supports Path A (HD-SDI input from J1 port convert to output HDMI at HDMI1/HDMI1A port) and Path B (HD-SDI input

from J2 port convert to output HDMI at HDMI2/HDMI2A port). See Figure below :

c. HD-SDI re-clock loop through output.

J1 HD-SDI input and re-clock loop through to J3 HD-SDI output. J2 HD-SDI input and re-clock loop through to J4 HD-SDI output.

d. HDMI (v1.3) x 2 output port.

Two HDMI output ports are HDMI1/HDMI1A, HDMI2/HDMI2A.

e. Stereo embedded audio support

f. On-board power on/off switch –

The power on/off switch is installed on SW1.

Specifications subject to change without notice

3 of 15

Page