Cisco Wap581 Panduan Memulai Cepat - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Titik Akses Nirkabel Cisco Wap581. Cisco Wap581 14 halaman. Reboot and reset to factory default settings
Juga untuk Cisco Wap581: Panduan Memulai Cepat (17 halaman), Manual (10 halaman)

Halaman Cetak
Cisco Wap581 Panduan Memulai Cepat
Verify that the Cisco WAP581 is powered on and the lights indicate
S
1
TEP
the appropriate links.
Locate the device's IP address. While there are different ways to
S
2
TEP
locate your device's IP address, this procedure uses Cisco FindIT.
a.
If you have previously downloaded Cisco FindIT, open Internet
Explorer and launch Cisco FindIT. For more information on
downloading Cisco FindIT, see www.cisco.com/go/findit.
b. In the Cisco FindIT display, place your mouse over the device's
name. The device IP address is displayed along with other
device information.
Open a command window by choosing Start > Run and enter
S
3
TEP
cmd.
At the command window prompt, enter ping and the device IP
S
4
TEP
address. In this example, we pinged 192.0.2.10.
If successful, you should get a reply similar to the following:
Pinging 192.0.2.10 with 32 bytes of data:
Reply from 192.0.2.10: bytes=32 time<1ms TTL=128
If it fails, you should get a reply similar to the following:
Pinging 192.0.2.10 with 32 bytes of data:
Request timed out.
Possible Cause of Installation Failure
No Power
• Power up the switch and your computer if they are turned off.
• Make sure your PoE switch is powered on and the lights indicate that
you have a link. See
• Verify that the devices on your network are not plugged into a
switchable outlet.
Bad Ethernet Connection
• Check the state of the indicator lights. See
Installation.
• Check the Ethernet cable to ensure that it is firmly connected to your
devices. Devices connected by the Ethernet cable can include the WAP
device, and routers, any switches, and your computer.
• Verify the connected switch has auto-negotiation enabled. The access
point and the switch need the same negotiation parameters set.
Cisco WAP581 Wireless Access Point
Verifying the Hardware
Installation.
Verifying the Hardware
9