Cisco WUMC710 Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Titik Akses Nirkabel Cisco WUMC710. Cisco WUMC710 17 halaman. 802.11ac
Juga untuk Cisco WUMC710: Panduan Instalasi Cepat (17 halaman), Panduan Pengguna (17 halaman)

Halaman Cetak

Linksys WUMC710

Setup > Basic Setup

The first screen that appears is the Basic Setup screen Use this screen to change

the browser-based utility's language, or to change the media connector's wired

Ethernet network settings

Language

This is used to set the language displayed by the browser-based

utility Select the desired language from the drop-down menu

Network Setup

This section determines if the media connector's IP address is obtained

automatically from a DHCP server, such as your network router (Automatic

Configuration - DHCP), or set manually (Static IP)

Device IP

If your network has a DHCP server, such as your network router,

assigning IP addresses to your network devices, then keep the default,

Automatic Configuration - DHCP The media connector will request an

IP address from the DHCP server (usually the network router) If no DHCP

server is found, then the media connector will use its default static IP address,

10.100.1.1, until it detects a DHCP server and is assigned a dynamic IP address

If you want to set a permanent static IP address for the media connector, then

select Static IP

If you select Static IP, then complete the following fields:

Static IP Address

Enter a unique IP address that will be used to access the

•

browser-based utility

Subnet Mask

Enter the subnet mask of your wired network

•

Default Gateway

Enter the IP address of the default gateway for your

•

network (in most cases, this is your router)

Click Save Settings to apply your changes, or click Cancel Changes to cancel

your changes

Wireless > Basic Wireless Settings

Use the Basic Wireless Settings screen to configure the media connector's basic

wireless and security settings

There are two ways to configure the media connector's settings, manual and

Wi-Fi Protected Setup Wi-Fi Protected Setup is a feature that makes it easy to

set up your wireless network If your network router supports Wi-Fi Protected

Setup and uses WPA or WPA2 security, then you can use Wi-Fi Protected Setup

to automatically connect the media connector

Configuration View

To manually configure your wireless network, select

Manual Refer to Basic Wireless Settings, page 8 To use Wi-Fi Protected

Setup, select Wi-Fi Protected Setup Refer to Wi-Fi Protected Setup, page 9

Advanced Configuration