Cisco 500 Series Panduan Pengguna - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem Konferensi Cisco 500 Series. Cisco 500 Series 46 halaman. Stackable managed switches
Juga untuk Cisco 500 Series: Manual Informasi Keselamatan (42 halaman), Manual (4 halaman), Mulai Cepat Quide (13 halaman), Panduan Memulai Cepat (21 halaman), Lembar data (5 halaman), Panduan Pengguna (4 halaman), Panduan Pengguna (6 halaman), Manual (40 halaman), Panduan Administrasi (48 halaman), Manual (24 halaman), Pemecahan Masalah dan Pemeliharaan (15 halaman), Panduan Referensi Cepat (7 halaman), Panduan Memulai Cepat (25 halaman)

Halaman Cetak
Cisco 500 Series Panduan Pengguna

Cisco Headset 560 Series Standard Base

The following table describes the Cisco Headset 561 and 562 Headset buttons.
Table 6: Cisco Headset 561 and 562 Buttons
Number
Button
1
2
3
4
N/A
Cisco Headset 560 Series Standard Base
The standard base charges your headset and has LEDs that shows your headset's battery level and call state.
You can also answer and end calls when you lift or place your headset on the base.
Cisco Headset 500 Series User Guide
6
Name
Description
Power and Call button
Use to power the headset on and off.
Press and hold for 4 seconds to power the headset off and on.
Incoming and active call management depends upon if you have one
call or multiple calls.
One call:
Multiple calls:
Mute button
Toggle the microphone on and off.
Volume buttons
Adjust the volume on your headset.
LED
Shows the headset status:
• Press once to answer incoming calls.
• Press once to put an active call on hold. Press again to retrieve a
call from hold.
• Press twice to reject an incoming call.
• Press and hold to end a call.
• Press once to put an active call on hold, and to answer a second
incoming call.
• Press once to put a call on hold. Press again to resume a call, or
press and hold until you hear a tone to end the current call and
to resume a held call.
• Press and hold until you hear a tone to end an active call, and to
answer another incoming call.
• Press twice to stay on a current call, and to reject a second
incoming call.
• Blinking red—Incoming call.
• Steady red—Active call.
• Blinking white—Firmware upgrade is in process or the headset
is pairing with the base station.
Your Headset