Cisco 500 Series Manual - Halaman 11

Jelajahi secara online atau unduh pdf Manual untuk Sistem Konferensi Cisco 500 Series. Cisco 500 Series 40 halaman. Stackable managed switches
Juga untuk Cisco 500 Series: Manual Informasi Keselamatan (42 halaman), Manual (4 halaman), Mulai Cepat Quide (13 halaman), Panduan Memulai Cepat (21 halaman), Lembar data (5 halaman), Panduan Pengguna (4 halaman), Panduan Pengguna (6 halaman), Panduan Pengguna (46 halaman), Panduan Administrasi (48 halaman), Manual (24 halaman), Pemecahan Masalah dan Pemeliharaan (15 halaman), Panduan Referensi Cepat (7 halaman), Panduan Memulai Cepat (25 halaman)

Headsets

Table 6: Cisco Headset 560 Series Multibase Multibase LEDs

Number

You select which call source you want to use with the call source controls on the Multibase. The LED next

to each selected source lights up when you select the source.

Even if you are connected to a source, the LED may not be lit. The source LED only lights when the source

is selected or has an active call. For example, you may be properly connected to a Cisco IP Phone, your PC,

and your mobile phone through Bluetooth. However, the respective source LED is only lit when it is selected,

has an active call, or has an incoming call. Press the source button to check if a source is properly connected.

The source LED flashes three times if there is no connection.

You can alternate between active call sources.

Note

Place an active call on hold before you change to a different call source. Calls on one call source aren't

automatically put on hold when you switch to a different call source.

Name

Battery Status LED

Call Status LEDs

Mute Status LED

Bluetooth Status LED

Cisco Headset 560 Series Multibase

Description

Indicates the headset battery charge and base status:

• Headset battery strength—LEDs blink and change to

solid as the battery charges.

• Headset update in progress—LEDs blink in sequence,

left to right.

• Headset and base not paired—All LEDs blink

• Power save mode—Middle LED shows solid.

The base enters power save mode when there is no call source

connectivity after 10 minutes.

Alerts you to the call state of each source:

• Active Source—Steady white

• Incoming call on a selected source—Blinks green

• Incoming call on an unselected source—Blinks green

• Active call on a selected source—Steady green

• Active call on an unselected source—Pulses Green

Alerts you when your headset is muted.

Alerts you to the Bluetooth status:

• Paired with a call source—Steady white

• Pairing mode—Blinking white

• Searching for a call source—Pulse white

• Bluetooth is Off—LED is off

Headsets