Epson ET-2550 Mulai di sini - Halaman 2
Jelajahi secara online atau unduh pdf Mulai di sini untuk Semua dalam Satu Printer Epson ET-2550. Epson ET-2550 4 halaman.
Halaman Cetak
5
Carefully seal the bottle using the reverse side of the
bottle tip for proper disposal.
6
Replace the ink tank cap securely.
7
Repeat the previous steps for the remaining bottles.
8
Close the ink tank unit cover.
9
Connect the power cord to the back of the product and to
an electrical outlet.
Caution:
Do not connect to your computer yet.
10
Raise the control panel and turn on the product.
Note:
If an error message appears, turn off the product and
check that no protective material has been left inside the product.
Caution:
Do not lower the control panel without first squeezing
the release bar underneath or you may damage the product.
11
To select English as your language, press the OK button.
If you want to change the language, press
it, then press the OK button.
Note:
You can change the language later using the product's
control panel. For more information, see the online User's Guide.
12
13
3
1
2
3
or
to select
When the message to see the setup manual is displayed
on the LCD screen, press and hold the OK button for
3 seconds.
Press the
button to start charging the ink. Ink charging
takes approximately 20 minutes. Ink charging is complete
when
stops flashing.
Note:
The ink bottles included with the printer are designed
for printer setup and not for resale. After some ink is used for
charging, the rest is available for printing.
Caution:
Do not turn off the product or load paper while the
product is charging or you'll waste ink.
Load paper
Make sure the product is not charging. Then flip the
feeder guard forward, raise the paper support, and tilt it
backwards slightly.
Slide the edge guide to the left.
Load paper, glossy or printable side up and short edge
first, against the right side of the rear paper feed slot.
3 seconds
20 minutes