Epson ET-2600 Mulai di sini - Halaman 3

Jelajahi secara online atau unduh pdf Mulai di sini untuk Semua dalam Satu Printer Epson ET-2600. Epson ET-2600 4 halaman.
Juga untuk Epson ET-2600: Panduan Cepat (17 halaman)

Halaman Cetak

Load paper, glossy or printable side up and short edge

first, against the right side of the rear paper feed slot.

Slide the edge guide against the paper, but not too tightly,

and flip the feeder guard back.

Pull out the output tray and raise the paper stopper.

Install software

Note:

If your computer does not have a CD/DVD drive or you are

using a Mac, an Internet connection is required to obtain the product

software.

Make sure the product is NOT CONNECTED to your

computer.

Windows

If you see a Found New Hardware screen, click

Cancel and disconnect the USB cable.

nsert the product CD or download and run your product's

software package:

www.epson.com/support/et2600 (U.S.) or

www.epson.ca/support/et2600 (Canada)

Follow the instructions on the screen to run the setup

program.

When you see the Select Your Connection screen, select

one of the following:

• Wireless connection

In most cases, the software installer automatically

attempts to set up your wireless connection. If setup

is unsuccessful, you may need to enter your network

name (SSID) and password.

• Direct USB connection

Make sure you have a USB cable (not included).

Mobile printing options

Connect wirelessly from your smartphone, tablet, or computer.

Print documents and photos from across the room or around

the world. See your online User's Guide for instruction or learn

more at www.epsonconnect.com.

Any problems?

Network setup was unsuccessful

• Make sure you select the right network name (SSID).

• Restart your router (turn it off and then on), then try to

connect to it again.

• The printer can only connect to a network that supports

2.4 GHz connections. If your router offers both 2.4 GHz

and 5 GHz connections, make sure the 2.4 GHz network

is enabled.

• If you see a firewall alert message, click Unblock or Allow

to let setup continue.

• If your network has security enabled, make sure you enter

your network password (WEP key or WPA passphrase)

correctly. Be sure to enter your password in the correct

case.

There are lines or incorrect colors in my printouts

Run a nozzle check to see if any of the print head nozzles are

clogged. Then clean the print head, if necessary. See the online

User's Guide for more information.

Setup is unable to find my product after connecting it

with a USB cable

Make sure the product is on and securely connected as shown: