Cisco MeetingPlace Audio Server 5.2 Panduan Peningkatan - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Peningkatan untuk Sistem Konferensi Cisco MeetingPlace Audio Server 5.2. Cisco MeetingPlace Audio Server 5.2 20 halaman. Telepresence conference system
Juga untuk Cisco MeetingPlace Audio Server 5.2: Panduan Pengguna (44 halaman), Panduan Memulai (46 halaman)
Halaman Cetak
How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM
If you have to pull out the power cable to connect it to the DVD-ROM drive, make sure that you put the
Step 5
power cable back into the drive bay. Slide the power cable back in as far as possible so that you can
access the cable from the back of the server.
Slide the DVD-ROM drive into the drive bay. You may not be able to fully insert the DVD-ROM drive
Step 6
because the IDE cable may bunch up.
Go to the back of server and carefully straighten out the IDE cable.
Step 7
Verify that the IDE cable clips are open and insert the IDE cable connector to the PIDEA receptacle,
Step 8
located above the PWR1 receptacle, as shown in
When you push in the connector, the top and bottom clips of the receptacle secure the connector.
Figure 7
Step 9
Reconnect the power cable connector with the red wire on top to the disk drive, located at top left. This
connector is keyed and can only be inserted one way.
Step 10
Reconnect the power cable connector with the red wire on top to the PWR1 receptacle. Use a flashlight
to ensure proper connection. This connector is keyed and can only be inserted one way.
If you do not reconnect the power cable connector properly, the server will be damaged and will not boot
Caution
up.
Go to the front of the server and insert fully the DVD-ROM drive into the drive bay and tighten the
Step 11
captive screws.
Replace the face plate of the drive bay and fasten the four screws.
Step 12
After completing the installation, verify all the connections.
Step 13
Remove the releasable tie wrap that is securing the floppy drive housing to the back of the server.
Step 14
Step 15
Reconnect the power cable connector with the red wire on top to the floppy disk drive. This connector
is keyed and can only be inserted one way.
Step 16
Slide the floppy drive housing back into the server and fasten the four screws. Take care not to pinch any
cables.
Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure
8
PIDEA Receptacle
Figure
7.
PIDEA Receptacle
78-16489-01