DigiTech BASS WHAMMY-V-01-Z Panduan Pemilik - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pedal Musik DigiTech BASS WHAMMY-V-01-Z. DigiTech BASS WHAMMY-V-01-Z 18 halaman.

Calibrating the Expression Pedal

In the unlikely event that the Expression Pedal does not respond properly or that the note does

not bend or return to the correct pitch, it may need to be re-calibrated. The following steps outline

the procedure for Expression Pedal re-calibration:

1. Disconnect the power from the Bass Whammy pedal.

2. Press and hold the E ect On/O Footswitch while reconnecting the power. This

enables MIDI and Calibration Setup. Wait for one of the Whammy, Detune, or

Harmony LEDs to begin ashing (indicating the currently selected MIDI channel) then

release the footswitch.

3. Rock the Expression Pedal fully forward (toe down) and fully back (toe up) at least two

times. The 4 Harmony LEDs will light back and forth (from OCT DN/4TH DN to OCT

UP/2 OCT UP) as the pedal is rocked indicating the pedal is calibrating.

4. When nished, press the E ect On/O Footswitch again to exit the MIDI and

Calibration set up and return to normal operation.