Epson L3110 Series Panduan Cepat - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Cepat untuk Semua dalam Satu Printer Epson L3110 Series. Epson L3110 Series 48 halaman.
Juga untuk Epson L3110 Series: Mulai di sini (4 halaman), Panduan Cepat (40 halaman), Panduan Cepat (48 halaman), Panduan Cepat (48 halaman), Panduan Cepat (36 halaman), Mulai di sini (2 halaman)

Halaman Cetak

Button Combinations

Reading the Indication Lights

: On

: Flashing

Error Status

Initial ink charging may not be complete. See the Start Here to complete initial ink charging.

No paper is loaded or more than one sheet has been fed at a time. Load paper and press the

A paper jam has occurred. Remove the paper and press the

& "Clearing Paper Jam" on page 45

If the indicator light continues flashing, see the jammed paper section from "Solving Problems"

in the User's Guide.

O When the power light is on or flashing, the printer was not turned off correctly. After

clearing the error by pressing the

recommend performing a nozzle check because the nozzles may have dried or clogged.

To turn off the printer, make sure you press the

O When the power light is off, the printer has started in recovery mode because a firmware

update failed. For more details, see the error indicator table from "Solving Problems" in the

User's Guide.

O Flashing simultaneously: An ink pad is nearing or at the end of its service life.

O Flashing alternately: A borderless printing ink pad is nearing or at the end of its service life.

Borderless printing is not available, but printing with a border is available.

To replace the ink pad or borderless printing ink pad, contact Epson or an authorized Epson

service provider.

A printer error has occurred. Open the front cover and remove any paper inside the printer. Turn

the power off and on again. If the error continues to occur after turning the power off and on

again, contact Epson support.

Press the

and

buttons simultaneously to run software on a USB-connected

computer and scan as a PDF file.

Press the

and the

Turn the printer on while holding down the

button.

buttons simultaneously to copy in draft mode.

button to print the nozzle check pattern.

button, cancel any pending print jobs. We

button.