Cisco Quick Set C20 Panduan Memulai - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Sistem Konferensi Cisco Quick Set C20. Cisco Quick Set C20 42 halaman. Tc7.3, english, december 2015
Juga untuk Cisco Quick Set C20: Panduan Memulai (41 halaman), Panduan Pengguna (44 halaman), Panduan Memulai (35 halaman), Panduan Referensi Cepat (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Pengguna (25 halaman), Panduan Pemecahan Masalah (37 halaman), Lembar Instalasi (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Memulai (32 halaman), Panduan Pengguna (48 halaman), Panduan Memulai (42 halaman), Panduan Memulai (46 halaman)

Cisco TelePresence Systems

GettinG started Guide

Table of contents

Introduction

remote control and on-screen menu

Configuration using the remote control and on-screen menu

Waking up the system

If there is no menu on screen, press

Home

remote control to show the menu.

If the system does not show a menu on screen:

• Make sure the monitor is connected and has been

switched on.

• Make sure the remote control has the batteries installed.

• Make sure the system is switched on.

If the system has just been switched on, wait a few minutes

to allow the system to start up.

If there is still no menu on screen, make sure the monitor

cable is connected to the basic video output connector. If in

doubt, see the Installation guide for your product.

Back to task overview

User interfaces

(

)

on the

Configuration

Appendices

Remote control and

on-screen menu