Cisco TelePresence Video Systems
Contents
Configuring H.323 and SIP
1.
(when not set by a provisioning system)
to get online and ready to place and receive calls, your system
must be set up properly. Your system uses either the H.323
protocol or the SiP protocol for video calls.
NoTe:
Contact your system administrator, or service provider,
for information about the network settings.
for networks administered through Cisco tMS (Cisco
telePresence Management Suite) your Cisco tMS adminis-
trator will help you to get online.
You can find information about admininistering through Cisco
uCM in the
Administering tC endpoints on CuCM
Back to task overview
D14639.09 Video Systems Getting Started Guide TC6.1, April 2013.
Introduction
User interfaces
H.323
if in doubt about any of the parameters below, contact your
system administrator or your service provider.
1. tap
Settings > Administrator >
2. enter the
input fields.
3. if you want to enter the address of the H.323 gatekeeper
manually, tap
and enter the
otherwise tap Auto.
4. if the H.323 gatekeeper requires authentication and you
want your system to authenticate itself to the gatekeeper,
guide.
tap
ON
in the
Login Name
otherwise, tap OFF.
5. tap
Save
saving.
6. review the System information page and verify the H323
settings.
if you successfully registered to the Gatekeeper the
is shown as
7. tap
Exit
to return to the home menu.
Confirguration
Configuration
H323.
H323 Number
and
H323 Id
in their respective
Manual
in the
Gatekeeper Discovery
section,
Gatekeeper Address
in the input field.
Authentication Mode
section and enter the
and
Password
in their respective input fields.
to save the changes, or
Undo
to leave without
Registered
in the H323 section.
15
Appendices
SIP
if in doubt about any of the parameters below, contact your
system administrator or your service provider.
1. tap
Settings > Administrator >
2. enter the SiP uri in the
3. tap the preferred transport protocol in the
section. if you select Auto, the system first tries to connect
using tlS, then tCP, and finally udP.
4. Select a
Proxy
Type. Step through the list of available
proxy types by tapping the - or + signs. the default type
is Standard.
5. if you want to enter the SiP proxy address manually, tap
Manual
in the
Proxy Discovery
Address
in the input field. if you want the system to obtain
the SiP proxy address automatically (dHCP), tap Auto.
6. if the SiP proxy server requires authentication you must
enter the
Login Name
input fields to authenticate your system.
7. tap
Save
to save the changes, or
Status
saving.
8. review the System information page and verify the SiP
settings.
if you successfully registered to a SiP server the
shown as
Registered
9. tap
Exit
to return to the home menu.
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Contacts
SIP.
URI
input field.
Default Transport
section and enter the
Proxy
and
Password
in their respective
Undo
to leave without
Status
is
in the SiP section.
Halaman Cetak